Midland Radio Weather Radio 7582 User Manual

MODEL 75-820  
40 CHANNEL PORTABLE MINI CB  
WITH 10 CHANNEL WEATHER RECEIVE  
5 MEMORY CHANNELS, MEMORY SCAN  
ALL CHANNEL SCAN, INSTANT CHANNEL 9/19  
HI/LO POWER, AUTO POWER SAVE  
BACK LIGHTED LCD DIGITAL CONTROL SCREEN  
 
1. Antenna connector: With BNC connector type. A mobile or base station antenna  
(adapter required) can be used to extend range.  
2. “Squelch” Control: For the maximum receiver sensitivity, the control must be  
adjusted exactly where the receiver background noise disappears.  
3. "ON/OFF" Volume Control.  
In ‘’OFF’’ position your transceiver is off. Turn this control clockwise to switch on  
the unit. Turn the knob clockwise a little more to set the audio level, until you get a  
comfortable sound level.  
4. Multifunction backlighted display. This liquid crystal display has been enlarged to  
show all of the operating modes.  
A. Shows the selected channel number or operating frequency.  
B. Indicates the received signal strength or the relative power of the transmit signal.  
C. RX: Indicates the receive mode is on.  
D. EMG: Icon appears to indicate the emergency channel 9 function is activated.  
E. LOW: Low icon appears when the low power function activated.  
F. SAVE: Indicates the save function is activated. This is an automatic function to  
increase battery life.  
G. LOCK: Indicates the keyboard lock function is activated.  
H. BATT: When this icon illuminates, it indicates the batteries are low and should be  
replaced or recharged.  
I. TX: Illuminates to indicate the unit is in the tx mode.  
 
J. DW: Illuminates when the dual watch mode is enabled.  
K. AM: Indicates the CB mode is activated.  
L. “F”: Indicates the function button has been activated. The function mode allows  
use of the modes inprinted on the function buttons face.  
M. “M/1”: Indicates the memory channel selection.  
N. SCAN: Illuminates to indicate the scan mode is activated.  
O. WX: When visible indicates your transceiver is in the weather receive mode.  
Select the appropriate channel with the up/down buttons.  
5. Hand Strap Mount: Attach the included hand strap to this point.  
6. Mic/Spk: Plug in an optional speaker/microphone in this jack. The Midland model  
22-410 speaker/mic or 22-430 throat mic with earphone is available from your  
Midland dealer or directly from Midland.  
7. LIGHT button: Press and release will cause the display backlight to turn on. It will  
automatically shut off after a few seconds.  
8. ”LCR’’ button: Pressing this button will recall the last selected channel.  
9. “F” button: This is a dual function button. Press and release to activate the “M1-  
M5” memory selections or for memory programming. Press and hold will cause the  
display to toggle between channel number and frequency readout.  
10. “PTT” button: Press to activate transmit.  
11. ”Channel UP” button: To skip to the next channel in CB or weather mode. Keeping  
this button pressed causes rapid incrementing.  
12. “Channel DOWN”: To skip to the previous channel in CB or weather mode.  
Keeping this button pressed causes rapid incrementing.  
13. “Control buttons”:  
a. “M1 CH9/19 Button”; Press this button and release to select emergnecy channel 9.  
Press and release again and highway channel 19 will be selected. Press and release  
again will  
cause return to the original channel.  
To select memory channel 1; Press the “F” function button and release. Then press  
“M1” button and release, memory channel 1 will be selected.  
the  
To program memory channel 1; Select the desired channel to be in memory 1. Press  
release the “F” function button. Press and hold the “M1” button until a “beep” is  
and  
heard and the M1 icon is displayed. The selected channel is now programmed in  
memory 1.  
b. “M2 DW Button”; To program the 2 dual watch channels, select the first channel.  
Press and hold the “DW” dual watch button until a “beep” is heard and the DW icon  
begins flashing. While the DW icon is flashing select the second channel, then press  
and hold  
flashing. The receiver  
the DW button again until a “beep” is heard and the DW icon stops  
will scan between the 2 programmed dual watch channels.  
To stop dual watch press the “DW” button. To resume dual watch press the “DW”  
button again.  
To select memory channel M2 press and release the “M2” button.  
 
To program memory channel 2 follow the instructions for programming memory  
channel 1, except substituting channel 2 for channel 1.  
c. “M3 SC Button”; To start scan, set the squelch to mute the background noise. Press  
and  
where a signal is received with enough strength to open the squelch. The squelch will  
remain stopped for a few seconds after the signal disappears to allow time to answer  
release the “SC” scan button, scan will begin. The scan will stop on all channels  
the call. To  
will also stop  
stop scan press the SC button. Pressing the UP/DOWN or PTT buttons  
the scan.  
To select memory channel M3 press and release the “M3” button.  
To program memory channel 3 follow the instructions for programming memory  
channel 1, except substituting channel 3 for channel 1.  
d. “M4 CB/WX Button”; To change between CB and weather receive, press and release  
the  
CB/WX button. To select weather channels press the up or down button.  
To select memory channel M4 press and release the “M4” button.  
To program memory channel 4 follow the instructions for programming memory  
channel 1, except substituting channel 4 for channel 1.  
e. “M5 Lock Button”; To lock out all button functions except PTT, press and release the  
LOCK button. To unlock, again press and release the LOCK button.  
To select memory channel M5 press and release the “M5” button.  
To program memory channel 5 follow the instructions for programming memory  
channel 1, except substituting channel 5 for channel 1.  
 
f. “M.SC H/L Button”; To change between high and low power, press and release the  
H/L button.  
To scan only the 5 channels in memory locations 1 through 5, press the “F” function  
button and release, then press and release the “M.SC” button. To stop memory scan,  
press the up, down, or PTT button.  
HOW TO OPERATE YOUR TRANSCEIVER FOR CB  
1. Insert the antenna in the antenna connector.  
2. Insert 6 alkaline or nic-cad batteries into the battery compartment, noting polarity.  
3. Rotate the ON/OFF volume control clockwise to turn the unit on. Adjust the volume  
for a normal listening level.  
4. Adjust the SQUELCH control.  
5. Select the desired channel by the up or down buttons.  
An optional mobile adapter is available that will transform your 75-820 into a mini  
mobile.  
Check with your Midland dealer or the Midland factory.  
Note: If the channel will not change, check that the “LOCK” button has not been  
pressed. In this case, press the the “LOCK” button to deactivate this function.  
To transmit: press and hold the PTT button, then talk into the microphone.  
To receive: simply release the PTT button.  
TO RECEIVE WEATHER  
Press the WX, button then select one of the channels in your area from the 10 channels  
available.  
CAUTION: DON’T EXPOSE THE DISPLAY TO EXTREME HOT OR COLD  
TEMPERATURES  
CARE OF RECHARGEABLE NI-CAD BATTERIES  
Always follow the battery manufacturers recommendations for charging  
and disposing of ni-cad batteries.  
The following is meant as general information regarding ni-cad batteries.  
1. Occasionally allow the batteries to fully discharge before recharging. Full discharge  
will be indicated by the low battery indicator coming on during receive operation.  
2. Always allow the battery to fully charge before using.  
3. The above will prevent the batteries from developing “memory” which effectively  
reduces their capacity.  
4. It is better to store ni-cad batteries that are discharged rather than charged.  
 
SPECIFICATIONS CB  
Channels  
Power Output  
Modulation  
1 through 40  
4 watts nominal  
90% +/- 5%  
<5%  
TX Dist  
Spurious and Harmonics  
Receiver Sensitivity  
Audio output  
<-60dbc  
0.7 uv for 10 db s/n  
4 watts  
Selectivity  
50 db  
SPECIFICATIONS WEATHER RECEIVER  
CHANNELS  
00  
01  
02  
03  
04  
163.275  
162.550  
162.400  
162.475  
162.425  
05  
06  
07  
08  
09  
162.450  
162.500  
162.525  
161.650  
161.775  
Sensitivity  
Audio Power  
Audio Load  
0.7 uV for 20 db  
4 watts  
8 ohms  
SERVICE:  
If it ever becomes necessary to return your unit for service:  
Pack the unit in its original box and packing. Improper packing may result in damage  
during shipment.  
Include a full description of any problems. Include your telephone number.  
You do not need to return accessory items (brackets, screws, power cord, antenna, etc)  
unless they may be directly related to the problem.  
Include a photocopy of the bill of sale or other proof of purchase showing the date of  
sale. This information must be included before warranty service can be considered.  
 
LIMITED WARRANTY  
Midland Consumer Radio Inc. will repair or replace , at its option without  
charge, any Midland Mobile, high power portable, FRS, or Base Station Citizens Band  
trancseiver which fails due to a defect in material or workmanship within one year  
following the initial consumer purchase.  
This warranty does not include any carrying cases, earphones, or telescoping  
antennas which may be a part of or included with the warranted product, or the cost of  
labor for removal or re-installation of the product in a vehicle or other mounting.  
Performance of any obligation under this warranty may be obtained by returning  
the warranted product, freight prepaid, along with proof of purchase date, to Midland  
Consumer Radio Inc., Warranty Service Department, 1670 North Topping Avenue,  
Kansas City, Missouri 64120, or to any “Midland Authorized Warranty Service Station,”  
or to the place of purchase (if a participating dealer).  
Warranty information and the location of the nearest “Midland Authorized  
Warranty Service Station,” may be obtained by writing Midland Consumer Radio,  
Warranty Service Department.  
This warranty gives you specific legal rights, and you may also have other rights  
which vary from state to state.  
Note: The above warranty applies only to merchandise purchased in the United States of  
America or any of the territories or possessions thereof, or from a U.S. Military  
exchange. For warranty coverage on merchandise purchased elsewhere, consult the  
supplemental warranty information included with this product or ask your dealer.  
Midland Consumer Radio  
1670 N. Topping  
Kansas City, Mo. 64120  
Printed in Thailand  
 

Laser MP3 Player MP4 P13 User Manual
Lexmark Printer 24T7401 User Manual
LG Electronics Battery Charger 37LB4D User Manual
Lincoln Electric Welding System IM870 A User Manual
Linear TV Cables 1066 User Manual
Marantz Stereo Receiver AV8802 User Manual
Matsushita Personal Computer CF W4HWEZZBM User Manual
Maverick Ventures Thermostat RT 01 User Manual
Metra Electronics Automobile Accessories 99 7330 User Manual
Metrologic Instruments Barcode Reader MLPN 2178 User Manual