Lennox Hearth Indoor Fireplace EBVCL User Manual

LOG PLACEMENT GUIDE  
EDVPF, EDVST, EDVCL, EDVCR, EBVPF,  
EBVST, EBVCL AND EBVCR SERIES  
750,161M  
REV. B 10/2004  
LOG PLACEMENT GUIDE FOR LENNOX DIRECT VENT AND B-VENT SERIES  
MULIT-OPEN GAS FIREPLACE HEATERS  
GENERAL INFORMATION  
This log placement guide has been prepared to present detailed log  
placement illustrations and provide instruction to assist in the place-  
ment of logs at the initial (new appliance) setup and after the annual  
cleaning and inspection cycles. The information provided here is to  
be used in conjunction with the Homeowner's Care and Operation In-  
structions provided together with this document in the appliance lit-  
erature packet. Please read the Homeowner's Care and Operation In-  
structions completely before completing the procedures detailed in  
this placement guide.  
Figure 1  
INITIAL INSTALLATION CONSIDERATIONS  
If the logs are being installed for the first time, the following para-  
graphs apply:  
DO NOT attempt to install the logs until the appliance installation has  
been completed, the gas line connected and tested for leaks and the  
initial burner operation has been checked out.  
Step 1. Remove the appliance front door.  
Step 2. Remove the foamed log set from the interior of the firebox.  
Remove the logs from their packaging. Handle logs carefully to pre-  
vent breakage.  
CERAMIC FLOOR PANELS, LOGS AND GLOWING EMBER  
PLACEMENT  
Glowing Embers  
Step 1. Install the Ceramic Floor Panels as shown in Figure 3 (for  
Direct Vent fireplaces only).  
Figure 2  
Note: This appliance is provided with enough Glowing Embers for sev-  
eral applications, do not feel compelled to use all that is in a new bag.  
For best glowing effect, replace the ember material annually. Replace-  
ment Glowing Embers are available (Catalog Number 88L53).  
Note: Do Not place Glowing Embers (Rockwool) over burner slots.  
Step 3. Separate the Glowing Ember (Rockwool) into pieces about  
the size of a quarter Figure 1. Keep the pieces fluffed up, not matted.  
Distribute these pieces over the front surface of the burner, as shown  
in Figure 2. Do not use more than is necessary. When properly posi-  
tioned, the Glowing Embers will cover approximately 65% of the front  
burner and with no appreciable gaps or openings. Ensure that the  
main burner ports remain uncovered by the ember material.  
Step 2. Position the individual logs as shown in Figures 4A and 4B  
on pages 3 and 4. Logs should be placed in the order shown. All logs  
that have notches to fit over the grate tines should be positioned with  
these notches directly against the grate. Proper log placement is criti-  
cal to encourage outstanding flame appearance and prevent sooting.  
When positioned properly as shown, logs will be positioned between  
flame peaks and will not impinge any flames.  
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.  
 
EDVPF, EDVST, EDVCL, EDVCR, EBVPF, EBVST, EBVCL & EBVCR LOG PLACEMENT  
Log  
Part  
Number  
6
4
2
Number Description  
1
2
3
4
5
6
Log, Corner  
55M1801  
55M1901  
55M2001  
55M2101  
55M2201  
55M2301  
Log, Rear/Left  
Log, Front/Left  
Log, Rear/Right  
Log, Front/Center  
Log, Center/Top  
Catalog Number for the entire log set: 55M0401  
1
3
5
Log (3) Lays Over  
3
Logs 1 And 2  
STEP 3  
1
STEP 1  
Place Bottom Hole Of Log (3) On Pin In Log (2). Position  
Grooves At The Bottom Of Log (3) Over The Grate.  
Position Groove At The  
Bottom Of Log (1) Over  
The Burner Log Support  
Bracket  
Position The Groove At The  
Bottom Of Log (1) Over The  
Grate And Slide It Forward  
Against The Grate Here  
Position And Slide Log (4)  
1
Against The Back Of The Grate  
STEP 4  
Position Log (2) Over The Grate  
Bar And Slide It Against The  
Back Of The Grate Here  
2
STEP 2  
Place Log (4) Over  
4
The Flat Spot On  
Position Groove At The Bottom Of Log (2)  
Over The Grate Here And Slide It Against  
The Back Of The Grate  
Log (1) Here  
Figure 4A  
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.  
3
 
EDVPF, EDVST, EDVCL, EDVCR, EBVPF, EBVST, EBVCL & EBVCR LOG PLACEMENT (CONTINUED)  
Log  
Part  
Number  
6
4
Number Description  
2
1
2
3
4
5
6
Log, Corner  
55M1801  
55M1901  
55M2001  
55M2101  
55M2201  
55M2301  
Log, Rear/Left  
Log, Front/Left  
Log, Rear/Right  
Log, Front/Center  
Log, Center/Top  
Catalog Number for the entire log set: 55M0401  
1
3
5
Position The Round End Of Log (6)  
Against The Notch Of Log (4) Here.  
Two Charred Spots Face The Front  
Position Small End Of Log (6)  
On The Notch Of Log (3) Here  
6
STEP 5  
3
4
Rest Log (5) Against  
The Grate Here  
Grate  
Assembly  
Position The Groove In The Back  
Of Log (3) Against The Grate  
Log (5) Sits In Front  
Of The Grate  
5
Figure 4B  
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.  
Lennox reserves the right to make changes at any time, without notice, in design,  
materials, specifications, prices and also to discontinue colors, styles and products.  
Consult your local distributor for fireplace code information.  
Printed in U.S.A. © 2003 by Lennox  
P/N 750,161M REV. B 10/2004  
1110 West Taft Avenue • Orange, CA 92865  
 

Land Pride Tiller 311 252M User Manual
Learning Resources Baby Toy LER 8544 User Manual
LG Electronics CRT Television CT 25 29M60RE RX User Manual
Life Fitness Bicycle CR300 User Manual
Linksys Network Router WAG300N User Manual
Listen Technologies Microphone DCN MICL User Manual
Manley Labs Stereo Amplifier STEREO 75+75 WATT AMPLIFIER User Manual
Marantz DVD Player DV6400 User Manual
Maytag Oven CWG4600 User Manual
Melissa Hot Beverage Maker 245 005 User Manual